If you do not carefully check the valve usage and performance specifications before installing the wafer-type electric butterfly valve, then the following common faults may occur for the clip-on electric butterfly valve: the valve cannot be reversed or the reversing movement is slow, the gas leaks, and the electromagnetic Failure of the pilot valve.
(1) The clip-on type electric butterfly valve cannot be reversed or reversed slowly. It is generally caused by poor lubrication, stuck or damaged springs, oil or foreign matter stuck on the sliding part. In this regard, it should first check whether the work of the oil mister is normal; whether the viscosity of the oil is suitable. If necessary, replace the lubricating oil, clean the sliding part of the wafer-type electric butterfly valve, or replace the spring and wafer-type electric butterfly valve.
(2) The clip-type electric butterfly valve is prone to wear of the valve core seal, damage to the valve stem and the valve seat after prolonged use, resulting in gas leakage inside the valve, slow movement of the valve, or failure in normal commutation. At this point, the seal, stem, and valve seat should be replaced, or the wafer-type electric butterfly valve replaced.
(3) If the electromagnetic pilot valve inlet and outlet holes are blocked by mud and other debris, loose seal, active iron core is jammed, circuit failure, etc., can lead to the clip-type electric butterfly valve can not be normal commutation. For the first three cases, the sludge and impurities on the pilot valve and moving core should be cleaned. The circuit fault is generally divided into control circuit faults and electromagnetic coil faults.
Before checking the circuit failure, the manual knob of the wafer-type electric butterfly valve should be rotated several times to see whether the wafer-type electric butterfly valve can be normally commutated under the rated pressure. If the normal commutation is possible, the circuit is faulty. During the inspection, the meter can be used to measure the voltage of the solenoid to see if it has reached the rated voltage. If the voltage is too low, the power supply in the control circuit and the associated trip switch circuit should be further checked.
If the wafer-type electric butterfly valve cannot be normally commutated at the rated voltage, check whether the electromagnetic coil's connector (plug) is loose or the contact is not true. The method is to remove the plug and measure the resistance of the coil. If the resistance is too large or too small, it means that the electromagnetic coil is damaged and it should be replaced.
Newly purchased wafer-type electric butterfly valve should be installed in a timely manner after unpacking. Generally, the valve manufacturers will debug the valve before leaving the factory. Do not loosen the parts on the valve at will. If you must check, you need to contact the manufacturer first.
Corn Thresher,Corn Sheller,Hand Corn Sheller,Corn Sheller Machine
Hunan Xinta Machinery Manufacturing Co., Ltd. , https://www.xyagriculture.com