In recent years, due to the rapid development of industry, the problem of environmental pollution has become more and more serious, especially in the winter, hazy days can be described as strange. The visibility of haze and sky is not only reduced, but also contains inhalable particles in the air. A lot of inhalation will have a certain impact on human health. In the same way, there are certain safety hazards in driving a car in a foggy day, because the visibility is relatively low, so the road conditions cannot be well grasped, and some minor accidents are inevitable during driving. Then how should we prevent car rear-end incidents when driving in fog?
1, keep a relatively low speed
The more serious the haze is, the shorter the visual distance is, the lower the vehicle speed must be. In order to avoid rear-end collisions, when the visibility is less than 200 meters and more than 100 meters, the speed shall not exceed 60 kilometers per hour; when the visibility is less than 100 meters and more than 50 meters, the speed shall not exceed 40 kilometers per hour; when the visibility is within 30 meters, the speed shall be controlled below 20 kilometers. In addition to maintaining a certain distance from the car, the distance between the front and rear cars is at least one or two body distances, and do not overtaking or changing lanes. Remember to turn left/right turn signals before changing lanes.
2, check the weather in advance
Before getting out of the car, you should pay more attention to the weather conditions of the road section you are going through and be aware of it. If, due to the weather, the highway that is going to pass through is subject to traffic control, it is necessary to arrange a detour route or wait. When arranging a detour route, pay attention to the height limit and vehicle limit line.
3, toll station, please slow down
When entering a toll booth, you must be especially careful. If the speed control is not good, you may end up with the vehicles waiting for payment in front, and you may even hit the toll gate. In general, there will be oscillating markings at the place where the toll station enters 500 meters before the stoppage. When the oscillating marking on the vehicle rolling occurs vibration, it must be decelerated immediately. However, if it is hazy days, see the toll booths, it is recommended not to open so fast, and other shock marks to remind you!
When the last Xiaobian wants to say, no matter how we hurry, we should pay attention to the safety of driving. This is the most important thing.
Extruder Single Screw,Extruder Screw,Single Screw Extruder,Single Screw
Zhejiang Zhongyang Screw Manufacturing Co., Ltd. , https://www.zhongyangscrew.com